Sea gull lighting 98852SW-986 Installation Guide download pdf (Page 2)

IMPORTANT SAFETY INSTRUCTIONS

• Besuretheelectricitytothesystemyouareworkingonisturned

off;eitherthefuseremovedorthecircuitbreakersetatoff.

• Useofothermanufacturerscomponentswillvoidwarranty,listing

andcreateapotentialsafetyhazard.

• Ifyouareunclearastohowtoproceed,contactaqualied

electrician.

• Properwiringisessentialforthesafeoperationofthisxture.

• Youdon’tneedspecialtoolstoinstallthisxture.

• Besuretofollowthestepsintheordergiven.

• NorelampingforLEDluminaire.

• Donotlookdirectlyatlightedbulb.

• Thisxtureisforundercabinetuseonly.

• CAUTION–Toreducetheriskofre,electricshock,orinjuryto

persons:

a.Useonlyinsulatedstaplesorplastictiestosecurecords;

b.Routeandsecurecordssothattheywillnotbepinchedor

damagedwhenthecabinetispushedtothewall;

c.Positiontheportablecabinetlightwithrespecttothecabinet

sothelampreplacementmarkingsareabletobereadduring

relamping;NA–NorelampingforLEDluminaire.

d.Notintendedforrecessedinstallationinceilings,orsofts;and

e.TheNationalElectricalCode(NEC)doesnotpermitcordsto

beconcealedwheredamagetoinsulationmaygounnoticed.

Topreventredanger,donotruncordbehindwalls,

ceilings,softs,orcabinetswhereitmaybeinaccessiblefor

examination.Cordsshouldbevisuallyexaminedperiodically

andimmediatelyreplacedwhenanydamageisnoted.

• Readinstructionscarefully.

SAVE THESE INSTRUCTIONS

Transformer Installation

Note-Donotexceedthewattagelimitationsforthetransformeryou

select.

6. PlugconnectingcordfromthetransformerintotherstLED

pucklightofrunorconnectinghub.

7. Bundleexcesscordneatlyandsecure.

Before You Begin

1. Carefullyremovethexturefromthecartonandcheckthat

allpartsareincluded,asshowningure1.Becarefulnotto

misplaceanyofthescrewsorpartswhichareneededtoinstall

thisxture.

Installation (Surface Mounting)

1. Makesureconnectingcablesareproperlypluggedinbefore

installation.

2. RaiseLEDpuckhousingtodesiredmountinglocation.

3. Tightensupportscrewstosecurehousingtomountingsurface.

Surface Mounting (No Exposed Wires)

1. Drill5/16"diameterholeandfeedconnectingcablesthrough.

2. Makesureconnectingcablesareproperlypluggedinbefore

installation.

3. RaiseLEDpuckhousingtodesiredmountinglocationand

positionovertheholewithcables.

4. Tightensupportscrewstosecurehousingtomountingsurface.

Installation (Recessed Mounting) 2 3/8"

diameter hole

1. Installsupportspringswithscrewsprovided.

2. Makesureconnectingcablesareproperlypluggedinbefore

installation.

3. Feedconnectingcablesthroughopenings.

4. Positionthepuckhousingsoverthedesignatedopeningand

pressinplace.

Interconnecting LED Pucks

1. Pucksareprovidedwith36"interconnectingcords(otherlengths

canbepurchasedseparately).

2. LEDPuckcanbedaisychained(interconnected)upto30Wof

totalpower.

3. LEDPuckscanbepoweredfromtheconnectinghub(6LED

pucksmax.perhub).

Hub Connection

UsehubonlywithportableLEDlights

#98859SW-12/-15/-787/-986

1. Raisehubtodesiredmountingpositionandsecurewithsupport

screw.

2. PluginthecablesfromLEDPucks.

3. Plugincablefromtransformer.

Helpful Tools

Outils Utiles

Herramientas Útiles

HC-1944FS 071012

Surface Mounting / Montage en Surface / Montaje de Supercie

Connecting Hub to Lx System

Relier le Plot au Système Lx

Conectando el Concentrador al Sistema Lx

Connecting Hub to Remote Transformer

Relier le Plot au Transformateur à Distance

Conectando el Concentrador al Transformador

Remoto

Connecting Hub to Transformer

Relier le Plot au Transformateur

Conectando el Concentrador al Transformador

Connecting Hub to Plug-In Transformer

Relier le Plot au Transformateur Enchable

Conectando el Concentrador

al Transformador de Enchufe

Recessed Mounting / Montage Encastré / Montaje Empotrado

9488 not supplied

9488 non fourni

9488 no incluido

96223S not supplied

96223S non fourni

96223S no incluido

9459 not supplied

9459 non fourni

9459 no incluido

Pucks can be connected to SGL LX system

powered with SGL Listed Class1 and Class2

power supplies only. To connect use SGL#9488

Fused Plug Only!

Les Pucks peuvent être reliés au système SGL

LX alimenté par une alimentation électrique SGL

Homologuée Classe 1 et Classe 2 uniquement.

Pour relier, utiliser une Prise Fusible SGL n°9488

uniquement !

El disco puede ser conectado al sistema SGL LX

impulsado solamente con fuentes de energía SGL

con Clasicación Nivel 1 y Nivel 2. Para conectar

utilice solamente Enchufe Fundido SGL#9488!

Plug-in, 12V 30/w Zero Load Electronic Transformer

Transformateur Electronique Zéro Charge Enchable 12V 30/w

Enchufe, Transformador Electrónico de Cero Carga 12V 30/w

• 98640S-12 black nish

Fini noir / Terminado negro

• 98640S-15 white nish

Fini blanc / Terminado blanco

LED puck connection hub

Plot connexion LED Puck /

Concentrador de conexión del Disco LED

• 98641S-12 black nish

Fini noir / Terminado negro

• 98641S-15

Fini blanc / Terminado blanco

Connector Cords

Cordons Connecteur / Cables Conectores

• 98643S-15 6" White Finish

6" Fini blanc / 6" white nish

• 98645S-15 18" White Finish

18" Fini blanc / 18" white nish

Fused Plug

Prise Fusible / Enchufe Fundido

• 9488-12

• 9488-15

LED Puck Lights

Lumières LED Puck / Luces de Disco LED

• 98859SW-12 black nish

Fini noir / Terminado negro

• 98859SW-15 white nish

Fini blanc / Terminado blanco

• 98859SW-787 bronze nish

Fini bronze / Terminado de bronce

• 98859SW-986 tinted aluminum nish

Fini aluminium teinté / Terminado de aluminio con tinte

2 LED Puck Light Kits

2 Lumières LED Puck / 2 Juegos de Luz de Disco de LED

• 98852SW-12 black nish

Fini noir / Terminado negro

• 988652SW-15 white nish

Fini blanc / Terminado blanco

• 98852SW-787 bronze nish

Fini bronze / Terminado de bronce

• 98852SW-986 tinted aluminum nish

Fini aluminium teinté / Terminado de aluminio con tinte

3 LED Puck Light Kits

3 Lumières LED Puck / 3 Juegos de Luz de Disco de LED

• 98853SW-12 black nish

Fini noir / Terminado negro

• 98853SW-15 white nish

Fini blanc / Terminado blanco

• 98853SW-787 bronze nish

Fini bronze / Terminado de bronce

• 98853SW-986 tinted aluminum nish

Fini aluminium teinté / Terminado de aluminio con tinte

LED Puck Lights and Accessories

Lumières palet de LED et accessoires

Luces LED de Puck y accesorios

HC-1944FS 071012

page 2 page 3

1 2 3

Comments to this Manuals

No comments

Sea gull lighting 98852SW-986 Installation Guide Page 2

Comments to this Manuals

Related products and manuals for Interface hubs Sea gull lighting 98852SW-986