GROUNDING INSTRUCTIONS: Wrap the ground wire from the fix-
ture (if supplied) and the ground wire from the outlet box (bare metal
or green insulated wire) around the green grounding screw on the
back plate (A); (Or if applicable).The green grounding screw is to be
inserted into the hole with two raised dimples provided on the
back plate (A).
NOTE: Underwriters Laboratories (U.L.) does not require all fixtures to
have ground wires. These fixtures still meet all U.L. specifications. The
listing mark of Underwriters on the product identifies products manu-
factured under its listing and Follow-Up Service Programs.
NEVER CONNECT GROUND WIRE TO BLACK OR WHITE
POWER SUPPLY WIRES.
CLEANING
ORDERING PARTS
To clean, wipe fixture with a soft cloth. Clean glass with a mild soap.
Do not use abrasive materials such as scouring pads or powders,
steel wool or abrasive paper.
Keep this sheet for future reference, and in case you need to order
replacement parts. All parts for this fixture can be ordered from place
of purchase. Be sure to use exact wording from illustration when
ordering parts.
GROUP A: CONNECT TO BLACK
HOUSE WIRE
BLACK
WHITE
GROUP B: CONNECT TO WHITE
HOUSE WIRE
INSTALLATION HC-844
STEP 1:
STEP 4:
STEP 1:
FINAL ASSEMBLY
STEP 2:
STEP 3:
Punch out appropriate holes in backplate [A], if applicable, to corre-
spond with holes in outlet box.
Make sure no bare wires can be seen outside wire connectors.
A
. Take note of the color of the wire(s) on your fixture. Identify
which group your fixture wire(s) falls into and connect the wires
according to the directions below:
B. Take your fixture wire(s) from group A and place evenly
against the black wire from the outlet box.
Do Not twist wires
together before using wire connectors.
C. Fit a wire connector (not supplied) over the wires and screw
the connector clockwise until you feel a firmness.
D. Try gently to pull the connector off the wires. If you can pull
the connector off, carefully re-do steps B and C, as above, and
check again for a firm connection.
E. Connect the fixture wire from group B to the white wire from
the outlet box in the same manner.
Push socket wires thru plastic bushing (If applicable).
Tuck wires into outlet box. Attach backplate (A) to outlet box by
placing outlet box screws (not supplied) through punched out holes
in backplate (A).
Install lamp.
STEP 3:
Secure support brace (D) and glass (E) to backplate with cap nuts
(R).
STEP 2:
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals